MacDon 9250 SP - Manual (Page 9)

Form # 46584 Issue 11/06 Web Rev_01 7
SAFETY
SAFETY SIGNS
• The safety signs reproduced below appear on the windrower at the locations listed.
• Keep safety signs clear and legible at all times.
• Replace safety signs that are missing or become illegible.
• If original parts on which a safety sign was installed are replaced, be sure the repair part also bears the
current safety sign.
• Safety signs are available from your Dealer Parts Department. The part number is printed in the lower R/H
corner of each safety sign.
To install safety signs:
1. Be sure the installation area is clean and dry.
2. Decide on the exact position before you remove the backing paper.
3. Remove the smaller portion of the split backing paper.
4. Place the sign in position and slowly peel back the remaining paper, smoothing the sign as it is applied.
5. Small air pockets can be smoothed out or pricked with a pin.