MacDon 9250 SP - Manual (Page 43)

Form # 46584 Issue 11/06 Web Rev_01 41
OPERATION
Attaching the Header (continued)
6. Connect driveline to header drive shaft as
follows:
• Open hinged shield at header drive shaft.
• Pull back spring loaded collar (G) on
driveline yoke and slide yoke onto header
shaft. Release collar, ensuring yoke locks
in position on shaft.
• Attach chain hook (if present) to hinged
shield at (H).
• Close hinged shield.
NOTE: For 962/963 Header only, attach chain
hook (if present) to shield (J) on connector shaft as
below.
7. Hydraulic Hose Connections:
910 Series Headers: No hydraulic connections
between header and tractor. Couple (A) to (B)
and (D) to (E) for these units. Failure to do so
will cause header drive circuit to overheat,
causing potential hydraulic component failure or
product performance problems.
920 & 930 Series Headers: Two connections
are made at couplers (A) and (B) at the header
right hand leg. One connection is made at
coupler (D) at the header left hand leg. For 912
& 922 Headers with Hay Conditioner equipped
with Hydraulic Roll Opener cylinders, connect
hose from these cylinders at coupler (C).
940, 960 & 970 Series Headers: Two
connections are made at couplers (A) and (B) at
the header right hand leg. Two connections are
made at couplers (C) and (E) at the tractor left
hand leg. One connection is made at coupler
(D) at the header left hand leg.
A - reel drive pressure
B - reel drive return
C - reel lift (or Hay Conditioner Roll Opener
cylinder circuit, if equipped)
D - conveyor drive pressure
E - conveyor drive return
8. Connect the header electrical wiring harness at
connector (F).
A
B
HYDRAULIC CONNECTIONS - R/H SIDE
D
F
C
E
HYDRAULIC & ELECTRICAL CONNECTIONS
L/H SIDE
CONNECT DRIVELINE –
912/922/933/972 HEADERS
G
H
J
CONNECT DRIVELINE – 962/963 HEADER