MacDon 9250 SP - Manual (Page 142)

Form # 46584 Issue 11/06 Web Rev_01 140
ASSEMBLY
Preparing the Tractor for
962/963 & 972/973 Headers
1. Remove plastic blocks (A) on tractor lift legs
and reinstall as shown with 1/2 x 5 inch bolts
provided.
NOTE: For 12’ 972 Header only, install
extensions (D) with 1/2 x 1 inch hex head bolts
and lock nuts.
2. For 972 Hydraulic Deck Shift Harvest Header,
install deck shift switch (B) (shipped with
header) in side console as follows:
• Cut decal to expose switch hole punch-out.
• Remove punch-out and attach wires from
harness to switch as shown.
NOTE: If header has a serial plate with
production year 2000-1 or older, the switch
provided with the header will be too small for
hole in console panel. Use backing plate if
provided, or order switch 109063.
• When header is attached, check function of
deck shift switch. Pressing left side of rocker
switch should shift decks to the left. If pressing
left side of rocker shifts decks to the right and
vice-versa, exchange positions of the two
outside wires at the switch, or reverse position
of switch in console.
A
REPOSITION LIFT LINKAGE BLOCKS
B
INSTALL DECK SHIFT SWITCH
(972 Hydraulic Deck Shift Headers)
DECK SHIFT SWITCH WIRING
LINKAGE BLOCK EXTENSIONS – 12’ 972
D