Orbit Baby Infant Car Seat and generation-one Base - Manual (Page 44)

86
86
Install the Base
Maintaining Y
our Orbit Infant System
86
86
Install the Base
87
87
Maintaining Y
our Orbit Infant System
87
87
the corresponding slots in the
Upholstery (Photo F).
4. Thread the lap portion of the straps
through the slot at the bottom of
the Center Panel (Photo G). Make
sure the straps can move freely
through the slots without any
interference from the hook and
loop fasteners.
5. Push the Buckle through the slot
in the Upholstery (Photo H). DO
NOT thread the Buckle through the
square hole.
6. Place the Buckle Pad back
onto the Buckle strap (Photo I),
positioning it to rest between your
child and the Buckle.
7. Wrap the top and bottom elastic
edges over the plastic rim (Photo J).
Hook the corners into place.
5. CHECK that the Center Panel’s
fasteners do not interfere
with the free movement of the
shoulder straps (Photo K).
6. CHECK that the Restraint Harness
is not twisted and pull on the straps
to make sure the Restraint Harness
is secure.
7. Attach the end of the Adjuster Strap
onto the Upholstery (Photo L).
8. Re-attach the end of the Sunshade
to the back edge of the Upholstery.
This is the last step for re-installing
the Upholstery in the Infant Car
Seat.
Cleaning cont’d G
H
I
Cleaning cont’d J
K
L