Orbit Baby Infant Car Seat and generation-one Base - Manual (Page 39)

76
76
Traveling with Y
our Infant Car Seat
77
Traveling with Y
our Infant Car Seat
77
11.While holding the strap in place,
slip both portions together into the
Belt Clip. (Photo K). Make sure the
belt cannot slip relative to the seat
buckle.
12. Re-buckle the lap-only belt into
place. You should apply weight
upon the Infant Car Seat again to
do so.
13. Slip the strap on the other side of
the Infant Car Seat into the other
Belt Clip. (Photo L).
14. CHECK that the Infant Car Seat is
at the proper angle. The bottom
edge of the Infant Car Seat MUST
be horizontal. If the bottom edge is
not horizontal, remove and re-install
the Infant Car Seat, using a folded
Traveling with Your Orbit Infant
System cont’d
L
It should not move more than 1” in
any direction, otherwise additional
vehicle seat belt tightening may be
needed.
To tighten further, unbuckle the
vehicle seat belt, remove from the
Belt Clips, shorten the length of
vehicle lap belt slightly and repeat
steps # 4 - 9.
Lap-Only Vehicle Seat Belt Routing:
10. While pressing down upon the
Infant Car Seat, pull on the extender
strap (if available) to tighten the
lap-only belt on the Infant Car
Seat (Photo I). Mark the length of
the lap-only belt by holding both
portions of the strap together near
the Belt Clip (Photo J) and unbuckle
the vehicle seat belt.
Traveling with Your Orbit Infant
System cont’d
K
M
I
J