Orbit Baby Infant Car Seat and generation-one Base - Manual (Page 22)

42
42
Install the Base Install the Base
43
43
To un-install the Base and remove it
from your vehicle:
1. Turn the StrongArm Knob
counterclockwise and reset the
Base StrongArm to zero (Photo CC).
2. If the Base is secured with LATCH,
push the red button on each LATCH
Connector and pull it from the
LATCH Anchor (Photo DD). Open
the Lock-Off Clamp to release the
LATCH Belt and store the LATCH
Connectors as shown (Photo EE).
If the Base is secured with a vehicle
seat belt, open the Lock-Off Clamp,
unbuckle the vehicle seat belt and
guide it through the Belt Guides.
3. Using both hands to support the
weight of the Base, remove it
carefully from the vehicle.
Removing the Base
(Photo BB), and repeat Steps
2 to 10. The towel should be
compressed as the StrongArm
tightens the Base into place.
- Try installing the Base in a
different seating position.
- Contact your vehicle dealer for
assistance and possible vehicle
seat belt modifi cation parts.
- Seek assistance from one of
the resources in the “Need Help
Securing Your Infant Car Seat
and Base?” section (page 44).
The Base must be properly level for
the Infant Car Seat to be safe. An
Infant Car Seat that is too reclined
can result in ejection during a crash,
and one that is too upright can
cause breathing diffi culties.
Do not use this Infant Car Seat and
Base until they are safely installed.
Installing the Base: With Vehicle Seat
Belts cont’d
CC
DD
EE
BB