Orbit Baby Infant Car Seat and generation-one Base - Manual (Page 43)

84
84
Install the Base
Maintaining Y
our Orbit Infant System
84
84
Install the Base
85
85
Maintaining Y
our Orbit Infant System
85
85
To remove the Upholstery:
1. Free the top and bottom edges
of the Upholstery from the Infant
Car Seat by unhooking each of the
corners near the Carry Handles
(Photo A).
2. Unbuckle the Restraint Harness.
Open the Center Panel by pulling
apart the hook and loop fasteners
(Photo B). Pass the shoulder
straps through the Center Panel.
3. Detach the Adjuster Strap from the
Upholstery (Photo C).
4. Release the fasteners holding the
Sunshade to the Upholstery.
5. Remove the Buckle Pad by pushing
the Buckle fi rmly through the slots.
This will take some effort, but will
not cause damage to the Buckle
Pad (Photo D).
6. Pull the Buckle through the slot in
the Upholstery (Photo E), which
completely frees it from the Infant
Car Seat.
To replace the Upholstery:
1. Undo the Chest Clip and release
the Buckle Tongues. Thread each
side of the Restraint Harness
through the Center Panel of the
Upholstery.
2. Position the Upholstery within the
Infant Car Seat.
3. Noting which plastic slots that
the shoulder straps are in, thread
the shoulder straps through
Cleaning cont’d A
B
C
Cleaning cont’d D
E
F