Orbit Baby Infant Car Seat and generation-one Base - Manual (Page 38)

74
74
Traveling with Y
our Infant Car Seat
75
Traveling with Y
our Infant Car Seat
75
relative to each other.
6. Re-buckle the shoulder-lap belt into
place. You should need to press
down upon the Infant Car Seat
again to do so. (Photo F).
7. On the other side of the Infant Car
Seat, slip the lap portion of the
vehicle seat belt into the other Belt
Clip. (Photo G).
8.
CHECK that the Infant Car
Seat is at the proper angle. If the
bottom edge is not horizontal,
remove and re-install the Infant
Car Seat, using towels to make the
Infant Car Seat level.
9. CHECK the security of the
installation by pulling the Infant Car
Seat in several directions (Photo H).
Traveling with Your Orbit Infant
System cont’d
If using a shoulder-lap vehicle seat
belt, continue with Step # 4.
If using a lap-only vehicle seat belt,
skip to Step # 10.
Shoulder-Lap Vehicle Seat Belt
Routing:
4. While pressing down upon the
Infant Car Seat, pull on the
shoulder-lap belt to tighten it
around the child restraint (Photo
C). To mark their position, hold the
shoulder and lap straps together
near the Belt Clip (Photo D) and
unbuckle the vehicle seat belt.
5. While holding the two vehicle seat
belt straps together, slip them
together into the Belt Clip. (Photo
E). Make sure the belts cannot slip
Traveling with Your Orbit Infant
System cont’d
F C
G D
E H