Orbit Baby Infant Car Seat and generation-one Base User Manual

Page 30

Install the Base

Securing Y

our Child

Install the Base

Securing Y

our Child

7. Insert both Buckle Tongues into the

Buckle (Photo N and O). You should
hear and feel a

CLICK as each

Buckle Tongue is inserted into the
Buckle.

8. Pull up on the Buckle Tongues to

CHECK they are locked (Photo P).
DO NOT use the Infant Car Seat if
the Restraint Harness does not latch
in place, and contact Orbit Baby.

9. Gently pull up on the shoulder

straps to tighten the lap section of
the Restraint Harness (Photo Q).

CLICK the buckle.
CLICK the chest clip.
CHECK by tugging on harness.

Buckling the Restraint Harness

cont’d

1. Open the Restraint Harness by

squeezing both sides of the Chest
Clip as shown (Photo L).

2. Unbuckle the Restraint Harness

by pushing the red button on the
Buckle.

3. Place your child into the Infant Car

Seat, making sure both back and
rump are fully supported by the
seating surfaces.

4. Position the Restraint Harness

around the child.

5. Make sure the Buckle Pad is

between the child and the Buckle.

CHECK that there are no twists in
the Restraint Harness straps (Photo
M ).

Buckling the Restraint

Harness