Orbit Baby Toddler Car Seat G2 - Manual (Page 62)

Maintaining Y
our Car Seat
122
122
Maintaining Y
our Car Seat
123
123
Re-installing the Upholstery
1. Re-attach the headrest by inserting the
two headrest tabs into the upholstery
slots corresponding with the shell
slot you will be using for the restraint
harness. Press the hook and loop
fasteners together (Photo A).
2. Ensure that the restraint harness
buckles are unbuckled, and that all
upholstery fasteners are pulled apart.
Position the upholstery within the car
seat.
3. Pull each side of the restraint harness
through the sides of center panel of
the upholstery (Photo B). Secure the
center panel closed.
4. CHECK that the shoulder straps are
threaded through the upholstery at
the same height as the corresponding
slots being used in the seat shell
(Photo C).
5. Thread the lap portions of the straps
through the slots at the sides of the
bottom of the center panel (Photo D).
Make sure the straps can move freely
through the slots.
4. Pull the crotch buckle back through the
opening in the bottom of the upholstery,
again making sure to use the same
corresponding upholstery slot as the
slot position used in the car seat shell
(Photo E).
5. Secure the elastic edges of the
upholstery by stretching them over the
rim of the car seat shell.
6. Insert the plastic side tabs into the slots
by the carry handles (Photo F).
7. Re-attach the shoulder pads and
CHECK that the shoulder straps move
freely through the slots and are not
twisted.
8. CHECK that the restraint harness is not
twisted and pull on the straps to make
sure the restraint harness is secure.
D A
E B
F C