Orbit Baby Toddler Car Seat G2 - Manual (Page 20)

Rear
-facing Installation
38
38
Rear
-facing Installation
39
39
Installing the Car Seat on the Car Seat Base: Overview
⚠WARNING⚠
Death or Serious Injury Can Occur
Never operate your vehicle unless the car seat is LOCKED into
the rear-facing position. Check both rotation indicators on the car
seat base. If either rotation indicator is red, re-secure the car seat to
properly lock it on the car seat base.
When a release lever on the car seat is pulled, the car seat is not
secured properly to the car seat base. Only use the release levers
when rotating or removing the car seat. Do not allow children to
operate the release levers.
Once the car seat base is installed (see your car seat base manual), the car seat
can be conveniently docked and locked onto the car seat base using the Orbit
Baby SmartHub
® . The car seat MUST be locked on the car seat base in the
rear-facing position when the vehicle is in motion.
1. Installing the car seat on
the car seat base:
See Docking the Car Seat
on the Car Seat Base.
Docking the Car Seat on the
Car Seat Base
Securing the car seat to the car seat base
requires first lowering the car seat to snap
into the SmartHub, then rotating the car
seat to lock into the rear-facing position.
1. Make sure the top of the car seat base
and SmartHub are clear of objects
(Photo A) before docking the car seat.
2. Grasp the car seat firmly (Photo B).
Dock the bottom of the car seat into the
⚠WARNING⚠
Death or Serious Injury Can Occur
PINCH HAZARD:
Ensure that your child’s fingers •
and hands are clear of release
levers and other moving parts.
When installing the car seat,
•
make sure the hands of other
vehicle occupants are clear of
the SmartHub area.
B
A