Orbit Baby Toddler Car Seat G2 - Manual (Page 55)

108
108
Using and T
raveling with Y
our Car Seat
109
Using and T
raveling with Y
our Car Seat
109
Weight Restrictions
LATCH Connector Storage
For toddler car seats installed with LATCH
and then transferred to the stroller, you can
store LATCH connectors in side pockets
while strolling (Photo A).
Top Tether Storage
When transferring the Orbit Toddler Car Seat
G2 to the stroller, always store the top tether
in the rear access panel so that it does not
drag on the ground or become tangled in the
stroller (Photo B).
Using the Stroller with Braces
The Toddler Car Seat G2 can still be used on
the stroller when the Side Impact Braces are
installed (Photo C).
Note: Using the braces will not allow
rotation of the car seat on the stroller. To
rotate your car seat on the stroller, remove
the braces and store them in the Cargo
Pod. The braces may be removed while
the car seat is docked on the stroller.
Your child must weigh 40 lbs (18 kg)
or less to use the Toddler Car Seat
G2 on the Orbit Stroller.
Using the Car Seat on the Stroller
Always secure your child with the restraint harness when using
the car seat with the stroller.
Avoid injuries to your child during stroller use:
Always fully support the car seat by firmly grasping both carry
•
handles when docking and undocking from the stroller.
Always make sure the car seat is securely locked into the
•
SmartHub of the stroller.
Only rotate the car seat when the stroller is stationary and the
•
parking brakes are locked.
Always make sure that the car seat is locked in front- or rear-
•
facing position before strolling. Side-facing positions are for
stationary use only.
PINCH HAZARD: Keep hands and fingers clear of moving parts,
the release levers, and the SmartHub.
⚠WARNING⚠
Death or Serious Injury Can Occur
Refer to the instruction manual that accompanied your Orbit Baby Stroller
for complete instructions on using and maintaining your stroller.
A
B
C