Orbit Baby Toddler Car Seat G2 - Manual (Page 45)

Forwar
d-facing Installation
88
88 Installing the Top Tether cont’d
Forwar
d-facing Installation
89
89
Forwar
d-facing Installation
89
89
3. Determine the shortest path from the
child restraint to the tether anchorage.
This may involve raising the vehicle
headrest so the tether belt travels
directly over the top of the seat (Photo
D).
4. Clip the tether hook to the tether
anchorage (Photo E). For more slack,
push down on the grey push-button
adjuster and loosen the strap.
5. Once the tether hook is clipped, pull on
the adjuster loop to remove all slack
from the tether (Photo F).
6. Verify that the tether is tight by pulling
forward on the top of the child restraint.
The car seat should not move more than
1 in (2.5 cm) at the belt path.
D A
E
F
1. To remove the top tether, push in on
the tether buckle’s grey push-button
adjuster and loosen the tether (Photo A).
2. Unclip the tether hook and replace
it in the rear access panel. Clip it to
the secured D-ring and store excess
webbing in the pocket inside the rear
access panel.
3. Close the rear access panel and secure
the panel with the clip.
Un-installing the Top Tether