De f g – Orbit Baby Toddler Car Seat G2 User Manual

Page 37

Forwar

d-facing Installation

Forwar

d-facing Installation

forward-facing strip at the back of
the car seat, and that the FRONT OF
VEHICLE arrow will face the front of
your vehicle (Photo D).

3. Slide both brace rods evenly into the

brace plug openings in the shell until
the brace is fully inserted and you
cannot see the brace rods anymore
(Photos E and F).

4. To lock the brace, first push the locking

knob in, then turn (Photo G). Tug on
the brace to ensure that it is locked in
position.

NOTE: A small amount of
movement is normal, but the
brace should not pull off.

5. Install the remaining brace on the other

side of the car seat by following Steps
1-4.

NOTE: The Toddler Car Seat G2 can still
be used on the Orbit Stroller when the

braces are installed. Place the car seat
either forward- or rear-facing.

However, the braces prevent the car
seat from rotating on the stroller and
can interfere with the Stroller Panniers
accessory. To restore full rotation on
the Orbit Stroller, remove the braces
and store them in the Stroller Cargo
Pod.

NOTE: The Toddler Car Seat G2 cannot
dock onto the Orbit Baby car seat base
when the braces are attached.

Attaching the Side Impact Braces, forward-
facing

cont’d