Orbit Baby Toddler Car Seat G2 - Manual (Page 33)

Rear
-facing Installation
64
64
Rear
-facing Installation
65
65
Rear
-facing Installation
64
64
To un-install the car seat and remove it
from your vehicle:
1. Unbuckle the lap-shoulder or lap vehicle
belt (Photo A).
2. Open the lower upholstery panel
marked by the blue dot (Photo B).
3. Open both arms of the blue lock-off
clamp to release the vehicle belt
(Photo C).
4. Close both arms of the blue lock-off
clamp and close the lower upholstery
panel.
5. Grasp the car seat firmly and remove it
carefully from the vehicle.
Un-installing the Car Seat:
With Vehicle Seat Belt
ball is in the blue level zone on the
Side Impact Brace (Photo P).
If the car seat is loose or if the white
indicator ball is not in the blue level
zone (Photo Q), remove and re-install
the car seat beginning at Step 2.
16. Lap-shoulder vehicle belt systems
in some vehicles have an Automatic
Locking Mode which locks the shoulder
portion of the belt and keeps it from
becoming a strangulation hazard to
older children or siblings. Orbit Baby
recommends engaging this mode by
pulling the shoulder portion of the belt
out completely from the vehicle, then
letting go. You should hear a soft clicking
sound as you allow the belt to retract
back into the vehicle. Check that you
are in the locking mode by tugging on
the shoulder portion of the belt and
verifying that it doesn’t extend.
17. Close the lower upholstery panel.
Installating the Car Seat: With Vehicle Seat
Belt
cont’d
A
B
C
P
Q