Orbit Baby Toddler Car Seat G2 - Manual (Page 41)

Forwar
d-facing Installation
80
80
Forwar
d-facing Installation
81
81 Installing the Car Seat:
With Vehicle Seat Belt
1. Attach the Side Impact Braces in a
forward-facing position: see pages 71-
73.
2. If you will be attaching the top tether
later (recommended; refer to page
85), open the rear access panel by
unclipping the back clip (Photo A).
Remove the tether hook from the
secured ring (Photo B).
3. Fully pull the top tether out of the
pocket. Close the rear access panel
and secure it with the clip.
4. Position the car seat forward-facing
on the vehicle seat. The car seat
should face the front of the vehicle.
The FRONT OF VEHICLE arrow on the
braces should point to the front of your
vehicle (Photo C). If using the top tether,
drape it over the rear of the vehicle seat;
it will be secured later.
5. If the vehicle seat back is adjustable, lock
the vehicle seat back into the upright
position.
back clip
rear access panel To un-install the car seat and remove it
from your vehicle:
1. Lengthen the LATCH belt by pressing
the grey push-button adjuster on the
buckle and pulling on the belt (Photo
A).
2. Push and hold the red button on each
LATCH connector and pull it off the
vehicle LATCH anchorage (Photo B).
Store the LATCH connectors in the rear
access panel or in the LATCH pockets
if using the car seat on the Orbit Stroller
(Photo C).
3. Grasp the car seat firmly and remove it
carefully from the vehicle.
Un-installing the Car Seat:
With LATCH
A
B
C
A
B
C