Orbit Baby Toddler Car Seat G2 - Manual (Page 50)

98
98
Securing Y
our Child
Securing Y
our Child
99
99
The headrest can be adjusted to the height
of your growing child and corresponds to
the position of the shoulder strap height.
1. Remove the edge of the upholstery from
the car seat shell by pulling it out from
under the rim. Pull out the plastic side
tabs from the slots next to each carry
handle (Photo A). This will allow you
to access the back of the upholstery
where the headrest is attached with two
tabs.
2. Note which upholstery slots the two
tabs are in, so that you can change their
location. Then, pull these two tabs away
to free the adjustable headrest
(Photo B).
3. Pull the adjustable headrest away from
the upholstery (Photo C).
4. Feed the headrest tabs back into the
new slots, making sure that they are
both threaded through slots at the same
height as the restraint harness on both
sides of the upholstery (Photo D).
5. Press the adjustable headrest tabs
firmly onto the corresponding hook-
and-loop fasteners on the back of the
upholstery (Photo E).
6. Replace the upholstery by stretching
it back over the top rim of the car seat.
Re-insert the plastic side tabs into the
slots by the carry handles (Photo F) and
pull the upholstery around the sunshade
openings in the car seat shell.
A
B
C
D
E
F
Adjusting the Headrest