Orbit Baby Toddler Car Seat G2 - Manual (Page 48)

94
94
Securing Y
our Child
Securing Y
our Child
95
95
2. Open the rear access panel and pull on
the restraint harness from the front to
pull up the metal splitter plate, along
with the strap loops (Photo E).
3. Unhook each shoulder strap loop from
the metal splitter plate (Photo F).
4. From the front of the car seat, pull the
shoulder straps out from their slots and
re-thread each shoulder strap through
the correct corresponding upholstery
slots and plastic shell slots (Photo
G). Note: It will be necessary to adjust
the headrest at the same time. See
Adjusting the Headrest on page 96.
5. CHECK that each shoulder strap is
threaded into slots at the same height
and that neither shoulder strap is
twisted.
6. Turn to the back of the car seat again
and secure each shoulder strap loop
entirely onto the splitter plate as shown
(Photo H).
F I
E H
D G
7. CHECK that the straps are secured by
pulling on the shoulder straps from the
front.
8. CHECK that the upholstery and
headrest around the shoulder strap slots
do not interfere with the free movement
of the restraint harness.
9. Close the rear access panel.
Adjusting the shoulder straps:
The shoulder straps can be adjusted using
the adjuster strap lock. It is located under
the lower upholstery panel denoted by the
blue dot at the front of the car seat.
1. To loosen shoulder straps, press down
on the adjuster strap lock and pull on
both shoulder straps (Photo D).
2. To tighten the shoulder straps, pull on
the adjuster strap that hangs from the
front of the car seat (Photo I).
Sizing the Restraint Harness to Your Child
cont’d