Orbit Baby Toddler Car Seat G2 - Manual (Page 44)

Forwar
d-facing Installation
86
86
Forwar
d-facing Installation
87
87
To un-install the car seat and remove it
from your vehicle:
1. Unbuckle the lap-shoulder or lap vehicle
belt (Photo A).
2. Open the upper upholstery panel
marked by the red dot (Photo B).
3. Open both arms of the red lock-off
clamp(s) to release the vehicle belt
(Photo C).
4. Close both arms of the red lock-off
clamp(s) and close the upper upholstery
panel.
5. Grasp the car seat firmly and remove it
carefully from the vehicle.
Un-installing the Car Seat:
With Vehicle Seat Belt
A A
B B
C C
Orbit Baby recommends using the top
tether at all times while forward-facing if
you have a LATCH tether anchorage in
your car; using the tether will improve the
stability of the child restraint and will reduce
risk of injury.
The tether should only be used when the
child restraint is forward-facing. The tether
should only be anchored to approved
anchorage points. Some tether anchors are
identified by a tether anchor symbol (Photo
A); check your vehicle owner’s manual for
locations and more information. Older cars
may not have tether anchorage points.
The Toddler Car Seat G2 should be fully
installed BEFORE attaching the tether.
1. If the tether is not already unclipped and
fully out of the rear access panel, open
the panel by unclipping the back clip
and unfastening the tether hook from the
plastic D-ring (Photo B).
2. Close the rear access panel (Photo C)
and clip the back clip.
Installing the Top Tether