Warning, Installing the car seat: with latch, Removing the side impact braces – Orbit Baby Toddler Car Seat G2 User Manual

Page 38: Ca b c

Forwar

d-facing Installation

Forwar

d-facing Installation

1. Attach the Side Impact Braces in a forward-

facing position: see pages 71-73.

2. To access the LATCH belt, open the rear

access panel by unclipping the back clip

(Photo A).

3. Remove the LATCH connectors from their

pockets (Photo B). The LATCH belt is
permanently attached to the car seat by a
black strap called the LATCH leash.

If you will be attaching the top tether later

(recommended; refer to page 87), unclip

and remove the tether hook from the

secured ring (Photo C).

4. For ease of installation, lengthen the

WARNING

Refer to your vehicle manual for the

maximum weight rating of its lower

LATCH anchors. Unless a higher

weight is specified by the vehicle

manufacturer, only install your

Toddler Car Seat G2 with LATCH until

your child reaches 40 lbs (18 kg).

Installing the Car Seat:

With LATCH

1. Un-install the Toddler Car Seat G2 from

your car or have the car seat docked
securely either directly forward- or rear-
facing on the Orbit Stroller.

2. Turn the locking knob on the Side

Impact Brace to the UNLOCKED
position by first pushing it in, then
turning (Photo A).

3. Pull out evenly on both sides of the

brace until the brace rods disengage
completely from the car seat shell
(Photo B).

4. By rotating one brace around, you can

nest the braces together in their storage
position (Photo C). Store them in the
Cargo Pod of your Orbit Stroller or
another safe place for later use.

Removing the Side Impact

Braces

back clip

rear access panel

LATCH connectors