Opticon RFS 6000 - Manual (Page 4)

U
SER
’
S
& S
ET UP MANUAL
RFS 6000
4
Before you begin your installation, be certain
that you have all the items listed below:
Remove the packaging and check for any
physical damage. We recommend you to save
all packaging: it should be used whenever you
need to transport your terminal for service.
Damage caused by improper repackaging is
not covered by the warranty.
RFS6000
package contents:
The RFS 6000 controller Antenna
ADDITIONALS FOR RFS6000:
Serial cable RS232 Power supply
THE
CONTROLLER
RFS6000
3
1
Before operation first screw the antenna into
the applicable hole of the controller by hand.
Use only the antenna as supplied by
Opticon. Antenna’s with other
specifications are not allowed.
Fix the antenna handtight. Screwing
the antenna too tight may cause serious
damage to the antenna.
The controller operates with the maximum
result if it can operate in free space. Place
the controller under the following conditions:
Check if the antenna is properly fixed.
Place the controller at a central point,
preferably as high as possible.
Avoid objects (for example metal objects)
in the near area that may reflect or
obstruct the radiation of the
electromagnetic field.
1. Antenna
short range antenna for radio frequency
communication
2. Power switch
3. Power LED (red)
ON: Power is ON
blinking at start: ready for download
continous blinking: no software detected
OFF: Power is OFF
4. Decode LED (green)
blinking: data received from Opticon device
OFF:
no data
!
!
1.4 DETAILED VIEW
1.1 UNPACKING
1.2 ANTENNA ASSEMBLY
1.3 POSITION