Opticon RFS 6000 - Manual (Page 11)

U
SER
’
S
& S
ET UP MANUAL
RFS 6000
11
This chapter contains information to solve
problems you may encounter when using the
controller.
It is possible that you may not solve the
problems, despite our descriptions. In this
case, please contact your supplier or the
technical support department of Opticon.
The controller does not respond to PC.
The red power LED is off.
Check if the power supply is properly
connected. If necessary reconnect.
The red power LED is on.
Check if the cables are properly connected.
If necessary reconnect.
Check if the baudrate in the application
corresponds with the baudrate of the PC.
The red power LED blinks continuously.
The controller does not detect software.
Software might not be downloaded or wrong
software might be downloaded. Download
the right application from the PC to the
controller.
Data from the communicating device is not
received.
The green decode LED is off.
Move the communicating device closer to
the antenna until you entered the field of
the antenna.
?
?
?
?
TROUBLE
SHOOTING
3
6
PRODUCT
ORDERING
INFORMATION
3
7
Controller
RFS 6000 RF controller A6020000010
Powersupply
5V power supply A50500N0010
Connection cables
RS 232 cable C40120N0170
DB25 male / DB 9 female