NTi Audio Digilyzer DL1 - Manual (Page 56)

56
Appendix
description
Parity error. The parity of the received
signals is not correct (problems on the
transmission line).
CRCC Error. The CRCC of the
channel status information is incorrect
(problems on the transmission line).
Audio signal based events
A clipping in the audio signal is
detected. The clipping detector is
configured in the Digilyzer setup
screen. The setting for “PPM OVER
THRESH” is stored within the log.
No audio signal but only zeros have
been found.
The measured word length or the
audio signal has changed (do
not confuse with the word length
signalized in the channels status).
Channel status based events
The professional / consumer
indication bit in the channel status
has changed.
The emphasis bit of the channel
status has changed.
The signalized sample frequency in
the channel status has changed.
DL1 event
Fr pArITY
Fr
BLoCKCrCC
Au
overLoAd
Au MuTe
Au WordLeN
Cs CoN/pro
Cs eMpHAsIs
Cs
FreQueNCY
remark
n.a. ADAT
10 rec./s
n.a. ADAT
10 rec./s
sample
10 rec./s
10 rec./s
n.a. ADAT,
10 rec./s
n.a. ADAT,
10 rec./s
n.a. ADAT,
10 rec./s