Multiquip RX 1510-C/-I/-CI - Manual (Page 72)

RX 1510-C/-I/-CI
– 72 –
F I 4 I00
F I 4200
5.4.3 Switching the machine off with the infrared control device
► Move the toggle switch "Start-Stop" on the infrared control from the switch
position "Neutral" to the right to switch position "Stop".
► The following code is displayed: „F I 4100”. The LEDS for generator and oil
pressure drop are active. The stop procedure is initiated.
► Code „F I 4200” is displayed, if no further signal is received from the generator
and from the oil pressure sensor.
Stop procedure
CAUTION
The transmitter is ready for use as long as the toggle switch "Start-Stop" is in the
switch position "Neutral".
► Always turn the transmitter off by switching the toggle switch to "Stop" during
breaks and after finishing work.
Start-up