beautypg.com

Inspection – Multiquip AR13HAR User Manual

Page 20

background image

page 20 — aR13Ha/aR13HaR ROLLeR (s/n 110301 & up) • OpeRaTiOn anD paRTs manuaL — Rev. #0 (06/22/11)

inspeCtiOn

3. If the hydraulic oil level is low, remove the hydraulic

oil cap (Figure 14) and fill with type ISO 46 anti-wear

type hydraulic oil to the recommended operating level.

Figure 14. Hydraulic Oil Reservoir Filler Port

WaTeR TanK CHeCK

1. To check the water tank water level, place the roller

on secure level ground.

2. The amount of water inside the water tank can be

visually inspected by reading the water tube (Figure

15) that runs vertically along the water tank at the rear

of the roller. This tube indicates the amount of water

inside the water tank. Total tank capacity is 40 gallons

(181 liters.)

Figure 15. Water Tank

REAR

ROLLER

WATER

TANK

WATER

TANK

CAP

WATER

LEVEL

TUBE

BaTTeRY CHeCK

A 12-volt DC battery (Figure 16) is shipped dry, and will

require a proper electrolyte level for operation.
ALWAYS be sure that the battery cables are properly

connected to the battery terminals as shown below.

Generally the RED cable will be connected to the positive

terminal of the battery, and the BLACK cable will be

connected to the negative terminal of the battery.

Figure 16. Battery

NOTICE

If the battery cables are connected incorrectly, electrical

damage will occur causing damage to the roller's

electrical circuits. Pay close attention to the polarity of

the battery when connecting the battery.

This manual is related to the following products: