Multiquip AR13HAR - Manual (Page 19)

aR13Ha/aR13HaR ROLLeR (s/n 110301 & up) • OpeRaTiOn anD paRTs manuaL — Rev. #0 (06/22/11) — page 19
inspeCtiOn
FueL CHeCK
1. To check the engine fuel level, place the roller on
secure level ground with the engine stopped.
2. Tilt the operator's seat (Figure 10) forward to gain
access to the fuel tank.
Figure 10. Fuel Tank Access
3. Read the fuel gauge (Figure 11) located on top of the
fuel tank to determine if fuel level is low.
Figure 11. Fuel Gauge
4. If the fuel level is low, remove the fuel filler cap/gauge
and fill with unleaded gasoline. Wipe up any spilled
fuel immediately.
DangeR
Motor fuels are highly flammable and can
be dangerous if mishandled. DO nOT
smoke while refueling. DO nOT attempt
to refuel the pump if the engine is hot or
running.
5. Pay attention to the fuel tank capacity when replenishing
fuel (Figure 12). Refer to the fuel tank capacity listed
on the specifications table.
Figure 12. Adding Fuel
6. After replenishing fuel, make sure fuel cap is securely
tighten to fuel tank. Return operator's seat to normal
operating position.
HYDRauLiC OiL CHeCK
1. To check the hydraulic oil level, place the roller on
secure level ground with the engine stopped.
2. Visually inspect the hydraulic oil sight glass (Figure
13) located on the right rear of the front drum. For
normal operation the hydraulic oil level must be below
the top and above the bottom of the sight glass. DO
NOT OVERFILL!
Figure 13. Hydraulic Oil Sightglass