MTS TestLine User Manual
Mts testline test system operation
Table of contents
Document Outline
- Technical Support
- Preface
- Safety
- System Introduction
- Key Concepts
- About This Chapter
- Understanding Your MTS Software
- Understanding MTS File Types
- Understanding the Control Loop
- Understanding Control Channels and Control Modes
- Using Detectors and Actions to Protect Yourself and Your Equipment
- Using the E-Stop Control
- Optimizing System Response Before Testing
- Understanding and Resolving Error Conditions
- Running the Example HCF Test
- About This Chapter
- Test Procedure Overview
- Station Equipment Checkup
- Turn on the Controls
- Open the Station Manager Application
- Verify Calibration Files
- Verify That the System Is Ready for Use
- Set Initial Limit and Error Detectors
- Set Initial Tuning Parameters
- Power Up the Pump and HSM
- Verify Control of the Actuator
- Perform Basic Displacement Performance Tuning
- Position the Actuator Using Displacement Control
- Turn Off Hydraulic Power
- Install the Specimen
- Prepare To Run Test
- Run the Example HCF Test
- Remove the Specimen
- If Necessary, Recover from a Tripped Displacement Limit
- Maintenance
- Decommissioning
- Index