MTS Landmark System - Manual (Page 79)

Now that specimen installation is complete, reset meter history by navigating to Station Manager >
Display > Meters and clicking the Reset button.
Prepare to Run the Test
Preparing to run the test consists of the following steps:
a) Perform Basic Performance Tuning (p. 79)
b) Switch to Peak Valley Meters (p. 88)
c) Adjust Limits for the Test (p. 89)
d) Show Station Manager Scope and Meters for the Test (p. 90)
e) Minimize Station Manager (p. 91)
Perform Basic Performance Tuning
Use the following guidelines for basic performance tuning.
1. Select the "Tuning" user access level.
Ensure that your user access level is Tuning rather than Operator. Enter the password Tuning (case
sensitive) if prompted.
2. Verify initial force tuning parameters.
MTS Landmark Test System Operation | 79
Running the Example HCF Test