MTS Landmark System - Manual (Page 61)

Note: This window may not appear in all cases.
5. Select a configuration and parameter set.
Under normal circumstances, you would select a configuration file and parameter set recommended
by the experts in your lab. However, for this example HCF test, select the Training config.cfg
configuration but do not click OK yet
Parameter sets are found in the lower left corner of the Open Station window. For this example HCF
test, select the hard specimen tuning parameter set and click Open. A set of windows may open
based on the last user’s window setup. Minimize any windows that come up as you will be bringing
them up as appropriate.
6. Ensure that the HSM (hydraulic service manifold) is off.
MTS Landmark Test System Operation | 61
Running the Example HCF Test