MTS Landmark System - Manual (Page 115)

Daily Inspections
Before the start of each day’s testing, do a quick inspection of the load unit. Following are typical things
that should be checked daily:
• Ensure that there are no leaks from lifts or locks.
• Check the drip pan and ensure that there are no leaks from the actuator, hydraulic service manifold,
servovalve, or accumulators.
• Ensure that electrical connections are tight, with no frayed or poorly routed cables.
• Ensure that hoses are routed properly, not wearing, and the fittings are not leaking.
• Hoses must be routed as to avoid direct heat sources, moving or abrasive equipment.
• Check actuator speed control functionality.
If any problems are encountered, they should be repaired before operating the load unit.
MTS Landmark Test System Operation | 115
Maintenance