MTS 709 Alignment System - Manual (Page 97)

709 Alignment System Alignment Wizard 97
Alignment Wizard
Once the system is functional with the alignment specimen installed, actual
alignment of the test frame and force train components involves loosening and
tightening various set screw adjustments on the 609 Alignment Fixture. The
following sections give you some guidelines as to which adjustments to either
tighten or loosen depending on the actual state of the system.
Contents
Angular Adjustments 100
If the X coordinate is negative 102
If the X coordinate is positive 101
If the Y coordinate is negative 104
If the Y coordinate is positive 103
Concentric Adjustments 105
Crosshead Mounted 609 Alignment Fixture 106
If the upper gauge X coordinate is positive 106
If the upper gauge X coordinate is negative 107
If the upper gauge Y coordinate is positive 108
If the upper gauge Y coordinate is negative 109
Base Mounted 609 Alignment Fixture 110
If the upper gauge X coordinate is negative 110
If the upper gauge X coordinate is positive 111
If the upper gauge Y coordinate is negative 112
If the upper gauge Y coordinate is positive 113