MK Diamond MK-2000 Pro - Manual (Page 27)

MK-2000 Pro Revision 01/02, Effective Date January 10, 2002 Page 27
MAINTENANCE AND TROUBLESHOOTING
4. Blade Dressing:
Like most cutting instruments, a diamond blade performs best when it is dressed. Over time and use,
diamonds on the outer edge of the blade will become smoothed or “glazed” over. This will reduce grinding
efficiency and may cause the blade to “wander” or bend giving the illusion of an alignment problem. When
this occurs, the blade will need to be dressed. The diamond blade can be dressed using the MK Dressing
Stick (part number 152972) and by following the steps below.
(C)
Position the Dressing Stick
against the Adjustable Cutting
Guide and the Ruler/Stop
(A)
Setup the MK-2000 PRO for
operation (See Setup,
Adjustment and Operation
(B)
Set the Adjustable Cutting
Guide to cut a 1/16-strip
Setup for
Operation
Set Adjustable
Cutting Guide
Adjustable
Cutting Guide
Ruler/Stop
(D)
Place the ON/OFF Switch in
the ON position
(E)
Verify cooling flow exists on
both sides of the blade
ON/OFF
Switch
OFF
Position
Cooling Flow
Points
(G)
Turn the Saw off when cutting
is complete
ON/OFF
Switch
OFF
Position
(F)
Cut the Dressing Stick 7 or 8
times to dress the Blade
Hold Work
in Position
Direction
of Cut