MK Diamond MK-2000 Pro - Manual (Page 11)

MK-2000 Pro Revision 01/02, Effective Date January 10, 2002 Page 11
UNPACKING, TRANSPORT, UNIVERSAL STAND and ASSEMBLY
UNPACKING:
Your MK-2000 PRO has been shipped from the factory thoroughly inspected. Only minimal assembly is
required.
Use proper lifting techniques when lifting the MK-2000 PRO.
CONTENTS:
In your container, you will find one (1) MK-2000 PRO, one (1) MK-2000 PRO movable cutting table, one (1)
adjustable cutting guide, one (1) electric water pump, one (1) pump discharge fitting, one (1) cooling transfer
tube, one (1) flow adjusting clamp, one (1) drain plug, one (1) blade wrench, one (1) owners manual, one (1)
pump manual and one (1) warranty card.
MK-2000 PRO Movable
Cutting Table
Adjustable
Cutting Guide
Electric
Water Pump
Pump
Discharge Fitting
Cooling
Transfer Tube
Flow
Adjusting Clamp
Drain Plug Wrench Owners
Manual
Pump
Manual
Warranty
Card
TRANSPORT:
1. The MK-2000 PRO weighs approximately one hundred and sixty-five (165) pounds; use care
when transporting.
2. Never transport the MK-2000 PRO with water in the Water Basin.
NOTE: 1. Lock the Cutting Head in the "DOWN" position and remove the Movable Cutting Table when
transporting the MK-2000 PRO.
2. The MK-2000 Pro is equipped with forklift brackets for in lifting and moving the saw.
The MK-2000 Pro is designed with legs in the front and rear for ease of transport. To transport –
• Verify the Movable Cutting Head is locked in the down position and the Movable Cutting Table is removed
• Position two people on either side of the saw
• From the side, grasp the front and rear of the saw
• Lift and transport the saw to the desired work location
Cutting Head
Locked Down
Lift Point
Remove Movable
Cutting Table
Lift Point
Forklift Bracket Forklift Bracket