Setup tcp/ip, Boot method, Setup tcp/ip -2 – Brother NC9100H User Manual
Page 91: Boot method -2
10 - 2 FRONT PANEL SETUP MENU
Setup TCP/IP
This menu has nine sections: Boot Method, IP Address, Subnet
Mask, Gateway, Host Name, WINS Config, WINS Server, DNS
Server and APIPA.
BOOT Method
1
(For MFC) Press
Menu
,
6
,
1
,
1
.
(For DCP) Press
Menu
,
4
,
1
,
1
.
2
Press
or
to select Auto, Static, RARP, BOOTP or
DHCP
.
3
Press
Set
.
4
Press
Stop/Exit
.
Static mode
In this mode the DCP/MFC IP address must be manually assigned.
Once entered the IP address is locked to the assigned address.
Auto mode
In this mode, the machine will scan the network for a DHCP server,
if it can find one, and if the DHCP server is configured to allocate an
IP address to the machine, then the IP address supplied by the
DHCP server will used. If no DHCP server is available, then the
machine will scan for a BOOTP server. If a BOOTP server is
available, and it is configured correctly, the machine will take its IP
address from the BOOTP server. After it is initially powered ON, it
may take a few minutes for the machine to scan the network for a
server.
The machine supports “POWER SAVE mode” and you are
using the AUTO Boot mode, POWER SAVE must be set to
OFF.