Brother NC9100H - Manual (Page 90)

FRONT PANEL SETUP MENU 10 - 1
10
10
Front Panel Setup Menu
LAN Main Setup Menu
With the Network (LAN) Board (NC-9100h Print/Fax Server)
installed, you can connect your machine into the network to use the
Internet FAX, Network Scanner and Network Printer.
1 Install the Network (LAN) Board (NC-9100h). For more
information, see Chapter 23 of User’s Guide included with the
machine.
2 Set up the machine for your Network using the control panel.
The LAN menu selections allow you to setup the Brother DCP/MFC
for your network and Internet Fax configuration. Press
Menu then
press the appropriate number for LAN, based on the selections
displayed on your machine. After you have displayed the LAN Main
Setup menu, there are seven main selections: Setup TCP/IP, Setup
Internet, Setup Mail RX, Setup Mail TX, Setup Relay, Setup Misc
and Scan to E-mail. Proceed to the menu selection you wish to
configure.
Please note that once you have specified a valid IP address for the
machine, it is also possible to configure many aspects of the DCP/
MFC using your favorite web browser. For added flexibility, the DCP/
MFC is supplied with the BRAdmin Professional Windows
®
software,
which also can be used to configure many aspects of the NC-9100h.
You can also set up using BRAdmin, Web BRAdmin software
and so on. For more information, see Chapter 11 or visit at:
http://solutions.brother.com.