Brother NC9100H - Manual (Page 117)

11 - 6 TCP/IP CONFIGURATION
Using ARP to Configure the Print/Fax
Server IP Address
If you are unable to use the BRAdmin Professional utility or the
FAX\MFC’s control panel and your network does not use a DHCP
server, you can also use the ARP command. The ARP command is
available on Windows
®
systems that have TCP/IP installed as well as
Unix systems. To use arp enter the following command at the
command prompt:
arp -s ipaddress ethernetaddress
Where ethernetaddress is the Ethernet address (MAC address)
of the Print/Fax server and ipaddress is the IP address of the Print/
Fax server. For example:
Windows
®
Systems
Windows ® Systems require the hyphen “-” character between each
digit of the Ethernet address.
arp -s 192.189.207.2 00 -80-77-31-01-07