Lenze Global Drive Cam Loader - Manual (Page 33)

L
1.1 EN - 05/2005 33
Global Drive Cam Loader
Operation
Editing settings on the worksheet
I
Tip!
If you want to change the settings of several axes/products you can also use the
command EditWProject settings....
In the Project settings dialog box that appears you can quickly change between the
different axes/products by clicking the corresponding tabs:
6.3.3 Adding a product
X
How to add a product to your worksheet...
1. Select EditWAdd product.
2. Go to the Project settings dialog box and enter the name and the product number
of the new product.
• The product name is indicated on your worksheet.
• The product number is indicated in the master line of your worksheet. Each
product number may only be assigned once.
• The maximum product number determines the minimum number of curves.
The maximally possible entry depends on the target system.
• Later on, the user can use the product number (cam profile number) to activate
the corresponding motion profile in the axis.
4Defining the product properties...
(^ 28)
3. Click OK to confirm the settings and close the dialog box.