Lenze E84DxxxxxxxxxR - Manual (Page 67)

EDS84DPNET EN 4.0 - 11/2010
L
67
Communication manual 8400 protec PROFINET
Parameter reference
Parameters relevant for communication
13 Parameter reference
This chapter supplements the parameter list and the table of attributes in the software
manual and the »Engineer« online help for the Inverter Drive 8400 protec by the PROFINET
parameters relevant for communication.
13.1 Parameters relevant for communication
This chapter lists the PROFINET parameters in numerically ascending order.

Software manual/»Engineer« online help for the Inverter Drive 8400 protec
General information on parameters is provided here.

Note!
PROFINET command "Reset to factory defaults"
If the "Reset to factory defaults" PROFINET command is executed by a supervisor
or an IO controller, the PROFINET-specific parameters will be reset to their
standard values:
•
C13000 | IP address
• C13001 | Subnetwork mask
• C13002 | Gateway address
• C13010 | Active IP address
• C13011 | Active subnetwork mask
• C13012 | Active gateway address
• C13864 | Active station name
• C13899 | Station name
• C13910 | I&M1 system designation
• C13911 | I&M1 installation site
• C13912 | I&M2 installation date
• C13913 | I&M3 additional information
• C13914 | I&M4 signature code