Lenze E84DGFCT - Manual (Page 16)

Communication manual 8400 motec EtherCAT®
Product description
Connections and interfaces
16
L
EDS84DMOTECAT EN 2.1 - 11/2012
 On delivery, the EtherCAT connections and the LEDs for the EtherCAT status displays
are already mounted and wired:
– EtherCAT input to plug connector X31
– EtherCAT output to plug connector X32
– LEDs to plug connector X55
 It is also possible to connect the EtherCAT and other inputs and outputs (e.g. digital
inputs) via the positions A1 ... A4 and B1 ... B4.
 For the connections, 5-pin M12 connectors or - alternatively - cable glands (cable cross-
section max. 1.0 mm 2 , AWG 18) can be used.
 The M12 connectors, cable glands and prefabricated system cables can be obtained
from various manufacturers.
 Wire the M12 connectors or cable glands used to the corresponding contacts of the
terminal strips/plug connectors X3, X4 and X61.

"Inverter Drives 8400 motec" hardware manual
Observe the notes and wiring instructions included.