Lenze E94AYCEC - Manual (Page 96)

10 Parameter reference
10.3 Parameters of the communication module for slot MXI2
96
Lenze · E94AYCEC Communication module (POWERLINK CN) · Communication Manual · DMS 3.0 EN · 08/2014 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
C14075
C14078
C14079
Parameter | Name:
C14075 | EPL SDO channel width
Data type: UNSIGNED_16
Index: 10500 = 0x2904
EPL index: 0x1F98.0x08
The code defines the maximum user data size of asynchronous frames. Protocol-specific headers for POWERLINK,
UDP/IP and others as well as service-specific headers are to be interpreted as part of the user data.
In the configured state, the C14075 values of all EPL nodes must be identical.
Setting range
(min. value | unit | max. value) Lenze setting
282 Byte 1500 282 bytes
 Read access  Write access  CINH  PLC-STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT
Parameter | Name:
C14078 | EPL CN: Max. time - MN detection
Data type: UNSIGNED_32
Index: 10497 = 0x2901
EPL index: 0x1F99
The code defines the time interval needed for detecting a managing node. If a booting controlled node detects a
managing node during the interval, it changes to NMT_CS_PREOPERATIONAL_1. If not, it changes to "Basic Ethernet
Mode".
Setting range
(min. value | unit | max. value) Lenze setting
0 μs 4294967295 10000000 μs
 Read access  Write access  CINH  PLC-STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT
Parameter | Name:
C14079 | EPL multi-stage node declaration CN
Data type: UNSIGNED_8
Index: 10496 = 0x2900
EPL index: See subcodes
This code indicates in which multiplexed cycle the controlled node is queried. The value entered must not exceed
the value in code C14074 .
If, for instance, the value "3" is entered in code C14074 , the multiplexed cycle is repeated every three cycles. If now
the value "3" is entered for one node in C14079/x, it is always queried only in the second cycle of the three
multiplexed cycles.
Setting range
(min. value | unit | max. value)
0 Cycles 255
Subcodes Lenze setting Info EPL index
C14079/1 0 cycles 0x1F9B.0x01
... ... ...
C14079/100 0 cycles 0x1F9B.0x64
 Read access  Write access  CINH  PLC-STOP  No transfer  PDO_MAP_RX  PDO_MAP_TX  COM  MOT