Landoll 2000 Series Row Crop Cultivator - Manual (Page 24)

3-14 F-140-0512 Edition
ASSEMBLY INSTRUCTIONS
Decal Placement
Decals are extremely important for naming purposes and
for alerting others to the presence of the machine.
PLACE ALL DECALS on the cultivator as shown in
Figure 3-11. Center them as nearly as possible between
the top and bottom on the frame bar. Sometimes, shank
spacing may position a tool frame too near the end of the
frame bar to place a reflective tape square exactly as
shown. Then place the square between the U-bolts on
the tool frame as near the proper location as possible. A
red reflective square is attached to the rear of the left-
and right-hand end tool frames at the factory. If any
decals become unreadable, or are destroyed during use,
get replacement decals from your Landoll dealer as soon
as possible, and replace them on the machine.