Landoll 2000 Series Row Crop Cultivator - Manual (Page 21)

ASSEMBLY INSTRUCTIONS
3-11
Figure 3-9: Spray Nozzle Mount Installation
Spray Nozzle Mount Attachment
The optional spray nozzle attachment adds a spray
accessory to the cultivator. One spray nozzle attachment
services two rows on the cultivator, so they should be
attached to every other tool frame (See Figure 3-9.)
1. Remove the 1-8 hex nut from the rear, top, parallel
linkage bolt. Install the spray mounting bracket to the
parallel linkage bolt and replace the nut. Tighten it
until the side plates are just snug against the bushing
of the top parallel linkage.
2. Assemble the spray nozzle arm mount to the spray
mount bracket and secure it with the 1/2-13 X 1 hex
head cap screw and hex jam nut.
3. Assemble the spray nozzle bars to each other.
Assemble the arm mounting bar with a 1/4-20 X
1-1/2 hex head cap screw, a spray nozzle arm
mount, and hex lock nut. There should be two sets of
these assemblies per attachment.
4. Assemble the remaining spray nozzle mounts to the
extended ends of the four spray nozzle bars with
1/4-28 X 1 hex head cap screws, and hex lock nuts.
5. Assemble these spray nozzle arm assemblies to
each end of the spray nozzle arm mount using a
u-bolt, u-bolt bracket, and nut.
545m104650 op
PARALLEL LINKAGE
BOLT
FRAME TOOL MOUNT
1/4-28 HEX
LOCK NUT
SPRAY NOZZLE
MOUNT
ATTACH SPRAY NOZZLES
AND HOSES HERE
1/4-28 X 1 HEX
HEAD CAP SCREW
1-8 HEX NUT
1/2-13 X 1 HEX
HEAD CAP SCREW
1/2-13 HEX JAM NUT
SPRAY MOUNT
BRACKET
SPRAY NOZZLE
BAR
SPRAY NOZZLE
ARM MOUNT
1/4-20 X 1-1/2
HEX HEAD
CAP SCREW
ARM MOUNTING
BAR
1/4-20 HEX
LOCK NUT