Landoll 2000 Series Row Crop Cultivator - Manual (Page 16)

3-6 F-140-0512 Edition
ASSEMBLY INSTRUCTIONS
Figure 3-4: Shank Installation
Shank Assembly
IMPORTANT
See Figure 3-4 for parts names. When assembly is
done, tighten all fastening hardware to the torques
listed in Table 2-1 and Table 2-2. Tighten u-bolts
evenly to show an even amount of thread on both
legs of the u-bolt.
1. Assemble the sweeps and half sweeps to the shanks
using 1/2-13 X 2-1/2 plow bolts, flat washer, split lock
washer, and nuts. Install spacer washers between
the shank and the sweep, as needed, to get desired
penetration angle.
IMPORTANT
If the optional shields are to be used, the shield
mounting brackets should now be installed (See
Section 4, “Operation and Maintenance” for
operation and maintenance procedures.)
2. Position the shank with the right-hand sweep (the
half sweep with the right-hand wing) under the rear of
the left end tool frame. Secure it with the shank u-bolt
and 5/8-11 hex lock nuts, and a 3/4-10 X 3 hex head
cap screw and hex lock nut.
3. Position the shank with the left-hand sweep (the half
sweep with the left-hand wing) under the rear of the
right most tool frame. Secure it with the shank u-bolt
and 5/8-11 hex lock nuts, and a 3/4-10 X 3 hex head
cap screw and hex lock nut.
4. Install the remainder of the shanks (with full sweeps)
on the inner tool frames the same way as the end
shanks described above.
3/4-10 X 3 HEX
HEAD CAP SCREW
5/8-11 HEX LOCK NUT
LONG SHANK
1/2 FLAT WASHER
1/2 SPLIT LOCK
WASHER
1/2-13 HEX NUT
TOOL MOUNT FRAME
3/4-10 HEX LOCK NUT
SHANK U-BOLT
1/2-13 X 2-1/2 PLOW BOLT
SWEEP
545m104598