Landoll 2111 Coulter Chisel - Manual (Page 54)

3-22 F-719-0413 Edition
ASSEMBLY INSTRUCTIONS
Light Installation
NOTE
See Figures 2-1 thru 2-10 for light bracket placement. If
no dimension is given for a bracket, it should be located
against frame member as shown in drawing.
1. Attach inner tail light mounting bracket supports to
the center frames using 1/2-13 x 8-1/2 hex head cap
screws, warning light bars, and hex lock nuts (See
Figure 3-13.)
2. Attach outer lh and rh light brackets to frame
weldment using 1/2-13 x 7-1/2 hex head cap screws,
warning light bars, and hex lock nuts.
3. Attach red brake lamps to inner tail light mounting
bracket supports and amber lamps to outer light
brackets using 1/4-20 x 1-1/4 hex head cap screws
and hex lock nuts.
4. Connect warning light harnesses to lights.
5. Attach SMV emblem and mounting bracket to rear
center frame bar using 1/2-13 x 5-1/2 hex head cap
screws, 1/4-20 x 3/4 hex head cap screws, and hex
lock nuts. The SMV sign should be centered on the
rear bar of the frame.