Landoll 2111 Coulter Chisel - Manual (Page 46)

3-14 F-719-0413 Edition
ASSEMBLY INSTRUCTIONS
Auto Reset Shank and Shovel
Installation
1. Attach each shank assembly to each clamp
assembly using 3/4-10 x 5 hex head cap screw in the
top hole, 3/4-10 x 4 hex head cap screw in the
bottom hole, and hex lock nuts. Be sure that twisted
shovels are placed correctly (See Figures 2-1 thru
2-9.)
NOTE
2. For shallower depths, it may be necessary to move
shank into upper mounting holes. For certain
conditions shank may also be rotated forward when
using twisted shovels.
1. Install 2 x 1 x 18 spikes or 1/2 x 4 x 26 twisted
shovels onto shanks as follows:
a. Connect 2 x 1 x 18 spike to each shank using
1/2-13 x 3 hex head cap screws, flat washers,
and heavy hex nuts (See Figure 3-7.).
b. Connect 1/2 x 4 x 26 twisted shovels to each
shank using 1/2-13 x 3 plow bolts, flat washers,
and heavy hex nuts. See Figures 2-1 thru 2-9
for proper locations of right hand and left
hand shovels.
IMPORTANT
Right and left twisted shovels are determined by
direction of dirt flow when facing the direction of
travel.