beautypg.com

Wheel lift installation – Landoll 2111 Coulter Chisel User Manual

Page 37

background image

ASSEMBLY INSTRUCTIONS

3-5

Wheel Lift Installation

1.

Position the lift under the lift bearing mount brackets
on the frame assembly (See Figure 3-2.)

IMPORTANT

The wheel lift arms should point toward the rear of
the machine with the cylinder anchors facing up.

2.

Install the lift to the frame assembly using 3/4-10 x 2
hex head cap screws, lift bearing caps, 4" bearings,
and hex lock nuts.

3.

Insert 1-5/8 x 1-1/4 x 1 bushing into each cylinder
mount plate of the shank lift.

4.

Attach base end of the 3-1/2 x 16 hydraulic cylinder
to the cylinder anchor plates of the frame assembly
using roll pin and clevis pin supplied with the cylinder.

5.

Attach rod end of each 3-1/2 x 16 hydraulic cylinder
to the lift using roll pin and clevis pin supplied with
the cylinder.

6.

Install 90

o

adapters in each port of both 3-1/2 x 16

cylinders.

IMPORTANT

Do not use 90

o

adapters with restrictors in ports of

3-1/2 x 16 hydraulic cylinders.

7.

Attach leveler tube to leveler mount plates on the lift
using hitch pin, 1-8 hex lock nut, and 1/2 x 2-1/4
slotted spring pin.

8.

Assemble the tires to the hubs. Tighten wheel bolts
evenly to assure proper wheel alignment. Wheel
bolts should be tightened to 90 ft.-lbs of torque. The
hoist can then be removed.

9.

Inflate the tire as recommended by the manufacturer.