Landoll SL/SLB/SLP/SLPB/SLPB TURFMAKER III - Manual (Page 53)

MAINTENANCE
4-5
Acre Meter
The battery operated acre counter uses 3 AA batteries.
The acre counter will display “LObat” when the batteries
require replacement. Remove the acre counter from the
implement and then the 4 screws on the back of the case.
Separate the housing from the rear plate. Replace the
batteries with 3 quality AA.
Roller Wheels
Occasionally it is necessary to loosen clamp bands and
tighten roller wheel assemblies. as nearly as possible,
peaks on rear wheels should line up with valleys on front
wheels. This requires adjusting both end clamps on the
rear axle drum.
Adjustment Procedure
IMPORTANT
Failure to locate clamp band bolt over weld will cause
clamp band to loosen and slide.
Adjust the front roller wheels first. Loosen clamp bands
and slide wheels snug against each other, centering the
entire assembly under the deflector shields. Locate the
bolt in the clamp band over the weld on the pipe. Slide
the clamp band against the end wheel and tighten the
clamp band bolt. See Figure 4-4.
To adjust the rear roller wheels follow the front wheel
procedure. Start aligning the peaks of the rear wheels
with the valley of the front wheels at the center of the rear
roller. This will provide the best alignment of worn
wheels.
Figure 4-4: Clamp Bands
Front
Rollers
Clamp Bands