Landoll SL/SLB/SLP/SLPB/SLPB TURFMAKER III - Manual (Page 31)

ASSEMBLY INSTRUCTIONS
2-21
Addition of Rear Box (Optional)
If a rear box kit is desired after the purchase of the
seeder, install it as follows:
Figure 2-28: Rear Seedbox Addition (1 of 4)
2. Remove right side seed box end
bracket. (On 8-ft and 10-ft models,
also remove light brackets.)
Slide end bracket off of rate adjust-
ment sleeve.
Step 1.
•Unplug acre meter and warning light
plugs.
•Loosen and remove large box seed shaft
coupling, and unscrew seed shafts at the
center of the seeder.
•Loosen transmission drive chain.
•Loosen and remove large outside seed
rate adjustment nut. ( Do not loosen 1/2”
nuts at ends of rate adjustment threaded
sleeve .)
Remove R & L brackets
3. Remove right seedbox.
4. Remove center seedbox bracket.