Landoll SL/SLB/SLP/SLPB/SLPB TURFMAKER III - Manual (Page 36)

2-26 1P124
ASSEMBLY INSTRUCTIONS
S-Tine Tire Track Remover
(Optional)
1. Attach the brackets to frame with U-bolts (1/2” x
4-1/2” centers x 7-1/2” deep), lock washers, and nuts.
Note that long ends of brackets are downward.
Brackets should be about 53 inches from center of
machine. See Figure 2-33.
2. Attach the tube to brackets using straps and bolts
(1/2” x 6”), lockwashers, and nuts.
3. Locate and install the S-tines as needed to cover
tractor tire tracks. Suggested pattern is to use 1-3/8”
point on center tine and 2-1/2” points on each side. If
needed, additional tines may be purchased and
installed. This kit must be used with standard 9J442
long three point hitch on pickup machines.
The Wheel Track Remover is furnished with 6 S-tines
more or less tines may be used as required.
NOTE
S-tines should not be operated any deeper than
necessary to remove tractor tire tracks. Otherwise, wet
soil is brought up which will stick to the rollers, draft load
is increased, and under some conditions, tines may
deflect back to rollers and break.
Figure 2-33: S-Tine Setup
Tractor Tire Depression
Tooth Tube
Bracket Assembly
S-tine
Clamp
Carriage
Bolt
2 1/2 Point
1 3/8 Point
Suggested Setting