Landoll SL/SLB/SLP/SLPB/SLPB TURFMAKER III - Manual (Page 52)

4-4 1P124
MAINTENANCE
Feed Cup Adjustment
All cups must be set the same to seed uniformly. To
check, set the adjusting nut to 0-A. All cups should be
closed. If not, there are three adjustments to make as
needed.
Figure 4-3: Feed Cup Adjustment
JAM NUT
SEED RATE
ADJUSTING NUT
LARGE
LOCKNUT
1. Jam nuts on both
ends of the micro-
meter are used to
adjust all cups the
same amount.
3. Individual cups can be
adjusted by loosening their
mounting bolts, moving cups,
and then re-tightening.
JAM NUT
SEED RATE
ADJUSTING NUT
LARGE
LOCKNUT
Front Box
Rear Box
SHAFT CLAMP
CAPSCREW,
1/4” X 5/8”
SELF-LOCKING FLANGE NUT, 1/4”
FRONT SEEDBOXES
2a. Front Box: Remove clamp that
joins seed shafts. Turn right hand
seed shaft in or out of left seed shaft
as required so all cups close at the
same time. See step 3.
2b. Rear Box: Loosen feed roll
coupling jam nuts and set screws.
Turn right hand seed shaft in or out
of coupling as required so all cups
close at the same time. See step 3.
LEFT SHAFT
RIGHT SHAFT
Rear Boxes
MOUNTING BOLT